ATTACHINGAND REMOVINGTHEVACUUMBAG
Attaching
1.Attachthevacuumbagto thevacuumbaghookon theblower/vacuumtube(Fig.3).
Vacuum Bag Hook
Fig. 3
,Slide the vacuum bag tube over the debris exhaust tube on the housing. Push the tube until the latching tabs on both sides click into place, securing the bag on the unit (Fig. 4).
__J
Latching Tabs
Debris Exhaust Tube
Vacuum Bag Tube
Vacuum Bag
Zipper
Fig. 4
Removing
1.Press the latching tabs on both sides of the vacuum bag tube and pull the vacuum bag down from the unit (Fig. 5).
2.Detach the vacuum bag from the vacuum bag hook.
Latching Tabs
IN
PRESS IN
INSTALLING THE SHOULDER HARNESS (Optional)
WARNING: Toavoidserious
personal injury,
never attempt to start the unit when standing, when the unit is clipped to the shoulder strap. Always follow the starting procedures as described in the ,Starting/ ,Stopping Instructions section.
The shoulder strap is an optional accessory.
1.Push the strap through the center of the buckle.
2.Pull the strap over the cross bar and down through the slot in the buckle (Fig. 6).
Fig. 6
,Snap the clip on to the support fittings on the front or back of the handle. Clip to the front portion of the handle when using the unit as a blower, and clip to the back portion of the handle when using the unit as a vacuum (Fig. 7).
Attach Here | for | |
_/ | Blowing | Attach Here for |
|
| Vacuuming |
Fig. 7
,While standing in the operating position adjust length to fit the operator's size. Pull tab to lengthen, pull strap to shorten (Fig 8).
\
Fig. 5 | Fig. 8 |