UN,'';(1116 AND SiT.UP
1, Be sure carton is right side up. cut end panels out and
fold flat on flo~r 'Re~Ql/e. i(!ner pack and roll unit out 9f
carton,:'
2.Assemble the right and left handle tubes to the unit with the rigl1t and left hatJdJesocket caps and bO;Jts.00 not
tigh'en.'
3.AsSemble the handle panel as$emblyover the right and lefthilr'ldle tubes :and secure with four slotted round head bolts ~~d lock nUts. Tighten 8111;hebolt$ on th~ handle assembly. Placeth.~h~dl~ grips ov~r:th~ end~o(the hand)e tubes.
4, Place;one,end af ~e IT)ast~rclutch .rod tt)roughtt:ie,hol~ at the bo~tom of the master clutch con1:roland the other end thr9ugb the hole in '!hetlipper heat the end of the left handlE!tube and $ecur¥.with the two cotter pins.
5, The tilling width is, ass~mbl~dfot 22" as,shippeq. For 11" tilling width r&move
Qutsrd~:Spool AS$smt;Jliesfr:6m stiaft;Replace clevispina!'ld
6.Attath the depth bat releas~handle to tbehandJei near the right handle grip with 8'slC)tte~headscr~w ~rid nut. Attach the upper dep'thbeT'relebse rod to the handle by hooking the loop~ end th~Qughthe ~at on the handle from the outside, Attach the opposite end down through the round h?le In t~e depth bar pivot plate, SecL)re witt1 i cotter pJn. Atta<J!:1the double bend enQ of ".thelower trip rod down through the slotted hole in the p.ivot plate: S~cure ~)th ~ wa~her andc9tter pin.. Thread~~f! Adjust; ment Link on t:he opposite end and ad;ustto align With hole in .Oepth Bar La~ch. Secure w.ith a cotter pm. Che9K
operat\on of Oep'thBi)t ReleaseHandl& aft~r:attaching rods, With Depth ~at Release Hanc!le @!ithe wuy uP. Depth B~r latch should release. for faiture to relea~.
Adju$1ment ~jnk,
7.Attach the depth ~r Into the bracket at the rear of the tiller frame using the short clevis p\n through one of the holes m the 'bar,s~cur'ingloViththe hair pin cotter. Use the pointed end of the d~Pth bar in the ground except when ~h~IoIseof 1he furrow plow IS ~esired,
