Cisco Systems (VIP6-80) Removing and Installing Port Adapters, Dual-Width Port Adapter, page

Models: (VIP6-80)

1 40
Download 40 pages 44.43 Kb
Page 19
Image 19
Removing and Installing Port Adapters

Step 5 Place the removed board on an antistatic mat or foam pad, or place it in an antistatic container if you plan to return it to the factory.

This completes the procedure for removing a VIP6-80. Proceed to the“Installing a VIP6-80” section on page 24.

Note If you have an RSP2 configured as the standby with HSA or HA enabled, continue with the following steps to finish the removal of the VIP6-80 from the router.

Step 1 Wait 20 to 30 seconds. This time will vary depending on the number of interfaces installed in your system.

Step 2 Reinsert the standby RSP2.

This completes the procedure for removing a VIP6-80 if you have an RSP2 configured as the standby RSP with HSA feature or HA features enabled. Proceed to the “Installing a VIP6-80” section on page 24.

Removing and Installing Port Adapters

This section describes how to remove and install port adapters. It includes the following sections:

Tools and Parts Required, page 19

Single-Width Port Adapter, page 20

Dual-Width Port Adapter, page 22

Connecting Cables to the Port Adapter, page 24

If you are not removing or installing a port adapter, proceed to the “Installing a VIP6-80” section on page 24.

Port adapters do not support OIR, so you must first remove the VIP6-80 before removing or installing the PA. Refer to the “Removing a VIP6-80” section on page 18 if you have not already removed the VIP6-80.

Tools and Parts Required

To remove or install a port adapter, you need the following tools and parts:

A new port adapter or a replacement port adapter (if replacing a failed port adapter, you should have an antistatic container for shipment back to the factory)

An ESD-preventive wrist strap between you and an unpainted chassis surface

Number 1 Phillips screwdriver

Note Always handle the port adapter by the carrier edges and handle; never touch the port adapter components or connector pins. (See Figure 4.)

Versatile Interface Processor (VIP6-80) Installation and Configuration Guide

 

OL-5078-01

19

 

 

 

Page 19
Image 19
Cisco Systems (VIP6-80) Removing and Installing Port Adapters, Dual-Width Port Adapter, page, Tools and Parts Required