Canon NP6218, FY8-13EX-000 service manual Installation

CHAPTER 8 INSTALLATION

15)Call up the service station, and request the RDD’s initial settings. (LED 4 @2(red) starts to flash upon receipt.)

@2

	LED1 LED2 LED3
	2	6
			BAT1
	1	1	1
LED5	SW2		SW3
	SW4
LED6
			2
LED4	IC6
				CN4

SW1

CN3 CN2

Fig. 8-717

16)Call up the service station to check if the initial settings have been successfully made; if the attempt has failed, reset the RAM once again starting with step 11) through 13).

Important:

You must confirm that the RDD’s settings are correct by calling the service station.

17)Check that you can place a telephone call from the RDD to the computer in the

service station.

Press the push switch 4 !7. LED6 @3(red) should come on; it will go out when

transmission ends successfully, or will start to flash if transmission fails. Retransmission is executed in response to a press on the push switch 4 !7while LED6 @3is flashing.

Transmission is canceled in response to a press on the push switch 1 @4while LED6 @3is flashing.

@3

	LED1 LED2 LED3
	2	6
		1	BAT1
	1		SW3	1
LED5	SW2	SW4
LED6				2
LED4	IC6		!7
				CN4

SW1

@4

CN3 CN2

Fig. 8-718

8-36 COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)