Thank you for purchasing the AudioSource ® AMP1200 Twelve Channel
FEATURES:
• 12 channels (6 stereo zones) in one convenient enclosure | • Manual, auto, or triggered on/off for integration into any |
• Stable Class AB design delivers superior audiophile sound | automated system |
quality and performance | • |
| troubleshooting |
• Bridgeable channel outputs provide additional power | • |
when needed | • Can be converted easily between |
• Independent channel gain controls allow the output of | tabletop configurations |
each speaker to be perfectly matched | • |
• Switchable 115/230V input voltage |
|
INSTALLATION:
AudioSource amplifiers are designed to help deliver a great audio experience. However, where you place the amplifier can
have a large effect on the performance you receive, and the life of the unit. If you are not
the amplifier near a source of heat or in an extremely humid or wet location.
CAUTION: All connections and switching must be done with the amplifier’s power switch positioned to ‘Off’. Connect the power cord last to be sure that the amplifier is off during all of your connections and set up.
AMP1200
FRONT PANEL:
1. Master Power Switch / Indicator LED | indicate its operational status.These indicators provide quick |
Front panel pushbutton power switch turns the amplifier | and easy troubleshooting of the system.If the circuitry deter - |
on and off. When the switch is on and the indicator LED | mines that a channel must be shut down due to excessive |
is red, the amplifier is in standby mode. The remote turn | heat or low impedance (a short), only the channels that are |
on switch (located on the rear) is either in the “trigger” | affected will be turned off causing the zone LED to turn red. |
or “auto” position. When the LED is blue, the amplifier is | The remaining zones will continue to operate and maintain a |
fully active. The master power switch will turn off the am - | blue LED status. Once the condition has been corrected for |
plifier no matter which power mode has been selected. | the zone in question, the status LED will return to blue. |
2. Zone Status Indicators | Note: When the power LED is red and the zone status LEDS |
Each pair of channels or zones has a | are not lit (off) indicates the unit is in stand by mode. |
(2)