Canon FY8-13EX-000, NP6218 service manual 10-103

CHAPTER 10 TROUBLESHOOTING

No.	Description	Settings			Remarks
311	Left/right margin adjustment	0 ~ 15	A higher setting increases the
	(Direct; home position for slide		margin on both left and right.
	shutter for blank exposure)		default:	8
			unit:	0.27 mm
312	Left/right margin adjustment	-10 ~ +10	A higher setting increases the
	(Reduce; travel distance of slide		margin on both left and right.
	shutter for blank exposure)		default:	0
			unit:	0.27 mm
313	Primary output voltage correction	-16 ~ +16	Enter the setting recorded on the label
	(corrects output voltage		after replacing the drum cartridge.
	determined by APVC)
314	APVC measured current shift	-40 ~ +40	Enter the setting recorded on the label
	(corrects the results of APVC)		after replacing the drum cartridge.
315	Voltage correction for	-16 ~ +16	default:	0
	measurement in APVC (corrects		unit:	16 V
	voltage for measurement applied		Enter the value recorded on the label
	at time of APVC)		on the composite power supply when
			replacing the composite power supply.
316	Measurement current correction	-10 ~ +10	default:	0
	for APVC (corrects current		Enter the value recorded on the
	measured at time of APVC)		label on the composite power
			supply when replacing the
			composite power supply.
317	Fluorescent lamp pre-heating	-9 ~ +9	default:	0
	current adjustment		Enter the value recorded on the
			label on the composite power
			supply when replacing the
			composite power supply.
318	Transfer output voltage	-4 ~ +4	Convert the value recorded on the
	adjustment (corrects transfer		label on the composite power
	voltage determined by ATVC)		supply as follows and change the
			value recorded on the service label;
			then, enter the value when replacing
			the composite power supply.
			Label	Input		Label		Input
			1	→	0	6	→	+1
			2	→	-1	7	→	+2
			3	→	-2	8	→	+3
			4	→	-3	9	→	+4
			5	→	-4
319	Arch adjustment when	0 ~ 63	A higher setting increases the arch.
	multifeeder is used (pick-up roller		default:	25
	OFF timing)		unit:	0.27 mm

COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON) 10-103