Canon NP6218 Ii. Unpacking And Installing The Copier, A. Unpacking and Removing Fixings

CHAPTER 8 INSTALLATION

II. UNPACKING AND INSTALLING THE COPIER

When a metal part is brought in from a cold to warm environment, droplets of water can develop on the surface of the part. This phenomenon is called condensation, and condensation in a copier can lead to faulty images. If the copier has been moved from a cold to warm place, leave it alone for about one hour or more before unpacking it.

A. Unpacking and Removing Fixings

Step	Work			Remarks
1	Unpack the copier.
2	Detach the plastic cover, and
	place the copier on the
	pedestal holding its grips; be
	sure to work in a group of two.
	Install the Cassette Feeding
	Module-B2 or -A2 (accessory)
	according to its Installation
	Procedure if the copier is to be
	placed on it.
3	Open the cardboard box, and	Check that none of the following accessories is missing:
	take out all the accessories.	•	Copy tray	•	Installation Procedure
		•	Cassette (Universal)	•	Operator’s Manual
4	Remove all tape from the	Make sure that the paper size plate and size label
	outside of the copier. Take out	(1 pc. each) is inside the cassette.
	the cassette from the cardboard
	box, and remove the cushions
	from inside the cassette; then,
	slide the cassette into the copier.
5	Remove the tape from the
	scanner fixing found on the
	outside of the left cover,
	remove the screw, and slide the
	fixing to the right to detach it to
	the front.
	• Keep the fixing stored for
	possible relocation of the
	machine.

8-2 COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)