Canon NP6218, FY8-13EX-000 service manual Installation

CHAPTER 8 INSTALLATION

Step	Work				Remarks
9	Select service mode No.
	313/314, and enter the settings
	recorded on the drum label.
	To select service mode,
	• Press the service mode
	switch (SW302) with a hex
	key.
	Select ‘3’ of the mode by
	pressing ‘3’ on the keypad
	and AE key; then, select ‘No.
	3 xx’ by pressing ‘x’ and ‘x’
	on the keypad and the start
	key.
		To enter settings,
		• Select ‘No. 313’ in service mode, and enter the
			setting recorded on the label (PRIMARY) using
			the keypad. (To enter ‘-’, press the % key before
			entering the setting.)
			Then, press the Start key to store the setting.
			To enter the setting for IP_OFST, select ‘No. 314’
			in service mode and work in the same way.
10	Execute ‘No. 401’ in service	The copier supplies toner from the toner container
	mode.	to the developing assembly (about 5 min).
	• Press the service mode
				Caution:
	switch (SW302), ‘4’ on the
	keypad, AE Key, and Start			• Do not turn off the power or remove the door
	key in sequence.			switch actuator while the machine is operat-
				ing.
11	Make sure that step 10 has
	been completed; then, turn off
	the power, and open the
	copier’s top unit.
12	Remove the static eliminator,
	and clean it with the static
	eliminator brush; then, set the
	static eliminator.

8-6 COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)