Canon FY8-13EX-000, NP6218 service manual Set screws Loosen the set Screw to free Totation Pulley

CHAPTER 3 EXPOSURE SYSTEM

1)Put the steel ball into the hole of the pulley, and wind the cable four times toward the flange and then nine times in the opposite direction; thereafter, fix it in place using the pulley clip.

2)As in w, set the mirror positioning tool between the No. 1 and No. 2 mirror mounts.

3)Loosen the screw on the mirror pulley mount as in e; then, temporarily fix the cable in position on the left stay.

4)Route the cable as shown in the illustration; engage t on the hook on the side plate, and engage the i on the tension plate on the lens mount.

5)Tighten the screw loosened in e, and fix the cable to the left stay.

6)Loosen the screws on the drive pulley once so that the tension of the scanner cable is even as in !0; then, tighten it once again.

7)Fix the No. 1 mirror mount and the scanner cable fixing as in !1.

8)Make adjustments so that the length of the cable is 34 ±1 mm as in o using a ruler.

Set screws	!0
	Loosen the set
w	screw to free the
	totation of the
	pulley.

Screw	e	Set the mirror
	Losen the screw,
		positioning tool
	and shift.
	i
	Re-tighten
	the screw.

o

y

34±1mm

Put the steel ball into	Pulley clip
the hole in the
pulley, and wind the
cable nine times
toward the inside
and four times
toward the outside;
then, fit the pulley clip.	Steel ball

q

t

r

u!1

Figure 3-410

3-14 COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)