Canon FY8-13EX-000, NP6218 service manual 8-15, Step

CHAPTER 8 INSTALLATION

Step	Work	Remarks
6	Fill out the label, and attach it
	to the drum unit cover.

7Lock the developing assembly, and close the copier’s top unit.

8Turn on the door switch using the door switch actuator; then, shift the power switch to ‘ON’.

9Select service mode No. 313/314, and enter the settings recorded on the drum label.

To select service mode,

•Press the service mode switch (SW302) with a hex key.

Select ‘3’ of the mode by pressing ‘3’ on the keypad and AE key; then, select ‘No. 3 xx’ by pressing ‘x’ and ‘x’ on the keypad and the start key.

To enter settings,

•Select ‘No. 313’ in service mode, and enter the setting recorded on the label (PRIMARY) using the keypad. (To enter ‘-’, press the % key before entering the setting.)

Then, press the Start key to store the setting.

To enter the setting for IP_OFST, select ‘No. 314’ in service mode and work in the same way.

10Turn off the power, and open the copier’s top unit.

11

Replace the static eliminator.

12

Turn on the power.

COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON) 8-15