Canon NP6218, FY8-13EX-000 service manual E010, E030, 10-66

CHAPTER 10 TROUBLESHOOTING

6.	E010
	Cause	Step	Checks	Results	Action
		1	Does the main motor rotate until	NO	Go to step 3.
			E010 is turned on?
Main motor unit		2	Set the meter to the 12VDC	NO	Replace the main motor
(M1; refers to			range. Does the voltage between		unit (M1).
main motor and			J303-3 (+; MMD) and J303-2 (-; 0
main motor			V) on the DC controller PCB
driver PCB as			change from about 0 V to about
single entity)			2.6 V or from about 5 V to about
			2.6 V when the Copy Start key is
DC controller				YES	Check the contact of the
			pressed or when WMUPR starts?
PCB					connector (J502) on the
					motor driver PCB and
					the wiring from J502 to
					the connector (J303) on
					the DC controller PCB; if
					normal, replace the main
					motor unit or the DC
					controller PCB.
Drive belt		3	Is the drive belt routed properly?	NO	Re-route the belt.
DC power		4	Is the voltage between the	NO	Check the wiring
supply			following connectors of the motor		between the connector
			driver PCB normal?		(J206) on the composite
			J501-1 (+; 34 V) and J501-2 (-; 0		power supply PCB and
			V)		the connector J501) on
					the motor driver PCB; if
					normal, see “DC power
					supply is absent.”
Main motor unit		5	Replace the main motor unit. Is	YES	End.
			the problem corrected?
DC controller				NO	Replace the DC
PCB					controller PCB.

7.	E030
	Cause	Step	Checks	Results	Action
		1 Is the total copy counter operating		NO	See “The copy counter
			normally?		fails to operate.”
DC controller				YES	Replace the DC
PCB					controller PCB.

10-66 COPYRIGHT © 1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)