Connecting Cables to the Port Adapter
Refer to the Installation and Configuration Guide that shipped with your specific port adapter for cabling instructions.
Installing a VIP6-80
This section describes the procedure for installing a
Note
Caution
Step 1
Step 2
Step 3
Caution
Step 4
Step 5
Caution
To ensure compliance with EMI approvals by providing a tight EMI seal for the Cisco 7500 and the Cisco 7000 series routers, install interface processors first in the interface processor slots closest to the RSP slots, and then work out to the interface processor slots furthest from the RSP slots. Refer to the “Product Description” section on page 3 for more information on the interface processor slots on your router.
If you removed a
Figure 3 shows the functional details of inserting the
Remove or insert only one
Use the following procedure to install a new
Attach an
Ensure that a console terminal is connected to the console port (on the RSP or RSP7000) and that your console is turned on, or that you have a reliable Telnet connection to the system.
Hold the
To prevent ESD damage, handle interface processors by the handles and carrier edges only, similar to that shown for port adapters in Figure 4.
Place the back of the
While keeping the
Use the ejector levers when installing or removing interface processors. An interface processor that is partially seated in the backplane might cause the system to hang and subsequently crash, and shoving or slamming the interface processor into the slot can damage the backplane pins and board.
Versatile Interface Processor
24 |
| |
|