ASSEMBLY INSTRUCTIONS

ATTACHING AND REMOVING THE VACUUM BAG

Attaching

1.Attach the vacuum bag to the vacuum bag hook on the blower/vacuum tube (Fig. 3).

Vacuum Bag Hook

Fig. 3

2.Slide the vacuum bag tube over the debris exhaust tube on the housing. Push the tube until the latching tabs on both sides click into place, securing the bag on the unit (Fig. 4).

Latching Tabs

Debris Exhaust Tube

Vacuum Bag Tube

Vacuum Bag

Zipper

Fig. 4

Removing

1.Press the latching tabs on both sides of the vacuum bag tube and pull the vacuum bag down from the unit (Fig. 5).

2.Detach the vacuum bag from the vacuum bag hook.

Latching Tabs

PRESS IN

PRESS IN

INSTALLING THE SHOULDER HARNESS (Optional)

WARNING: To avoid serious personal injury,

never attempt to start the unit when standing, when the unit is clipped to the shoulder strap. Always follow the starting procedures as described in the Starting/ Stopping Instructions section.

The shoulder strap is an optional accessory.

1.Push the strap through the center of the buckle.

2.Pull the strap over the cross bar and down through the slot in the buckle (Fig. 6).

Clip

Fig. 6

3.Snap the clip on to the support fittings on the front or back of the handle. Clip to the front portion of the handle when using the unit as a blower, and clip to the back portion of the handle when using the unit as a vacuum (Fig. 7).

Attach Here for

Blowing Attach Here for

Vacuuming

Fig. 7

4.While standing in the operating position adjust length to fit the operator’s size. Pull tab to lengthen, pull strap to shorten (Fig 8).

Fig. 5

Fig. 8

9