Yard Machines 611 Attaching Clutch Grips, Attaching Handle Panel, Attaching Speed Selector Plate

Attaching Clutch Grips

(Use Hardware Group B.)

•Slide the pivot rod into the cover tube as shown in Figure 3.

NOTE: In some models, the pivot rod and cover tube may be pre-assembled.

Pivot Rod

Cover Tube

Carriage

Bolts E

Lock

Washer C

	Speed
Self-Tapping	Selector
	Plate
Screws F
		Lock
		Washer C	Carriage
			Bolts E

Figure 3

•Place the clutch grips in position on the rod as shown in Figure 4. Thread hex nuts (D) onto each end of the rod. Tighten nuts allowing the clutch grips to move freely on the pivot rod. See Figure 4.

Clutch

Grips

Pivot Rod with Cover

Hex Nuts D

Figure 4

•Insert clutch grip and rod assembly into handle tabs. Clutch grips must sit on top of the handles. Thread hex nuts (D) on each end to hold into position. Do not tighten. See Figure 5.

Clutch Grip and

Rod Assembly

Handle

Tab

Hex Nut D

Figure 5

Attaching Handle Panel

(Use Hardware C.)

•Position the handle panel between handles. Insert two carriage bolts (E) on each side and secure with lock washers (C) and hex nuts (D). See Figure 6.

Self-Tapping

Screws F

Figure 6

Attaching Speed Selector Plate

(Use Hardware D.)

•Assemble the speed selector plate to the outside of the handles as shown in Figure 6. Secure using two self-tapping screws (F) on each side.

Attaching Shift Lever

•Insert the shift lever through slot in the speed selector plate. See Figure 7.

NOTE: The bend in the lever should be towards the operator.

Shift

Lever

Hex
Bolt	G			Speed Selector
				Plate
			Hex Lock Nuts H
		Hex
		Bolt G
			Shift Lever
			Spring

Figure 7

•Secure shift lever to the shift lever spring using two hex bolts (G) and hex lock nuts (H). Tighten both

7