ASSEMBLY INSTRUCTIONS
NOTE: The only assembly required for your trimmer is to install the debris shield and adjust the assist handle.
DEBRIS SHIELD INSTALLATION
1.Position the motor housing with string head carrier fac- ing up (Figure 1).
2.Place the debris shield (A) on the tube so the holes align with the slots on the bracket (B). (Figure 2)
3.Install the Shield knob and nut (C) and tighten secure- ly.
A
C
Fig. 2
B
Fig. 1
OPERATING INSTRUCTIONS
CONNECT THE CORD
1.Ensure the cord is NOT plugged into a receptacle before this procedure.
2.Make a loop with 8” - 10” (20 - 25cm) of the end of the extension cord.
3.Place the loop into the slot (A) under the motor hous- ing and lock into place with cord retainer (B) in Fig. 3
4.Connect the extension cord to the trimmer.
5.Plug the extension cord into a receptacle ONLY when you are ready to operate the trimmer.
ADJUST THE ASSIST HANDLE
NOTE: The assist handle is attached to the shaft but has been turned under for packing
1.Loosen adjustment knob and rotate handle to the top of shaft (Figure 4).
2.Retighten adjustment knob securely.
Fig. 4
B A
Fig. 3
7
