OPERATING INSTRUCTIONS
BEFORE OPERATING:
Be thoroughly familiar with all controls and how to use them before operating the Dethatcher/Slicer. Make the following checks and perform the service as required before each start up.
PRE-START CHECK LIST
CHECK ENGINE OIL and bring level up to full. (Refer to engine manual for oil specifications).
CHECK AIR CLEANER and service according to instructions in Engine Manual.
FILL FUEL TANK where fumes will be safely dissipated. Refer to Engine Manual for fuel specifications.
CHECK DETHATCHER OR SLICER SHAFT ASSEMBLY to make sure it is free of dirt and other debris.
CHECK EXTERNAL SURFACES and remove any dirt and dust accumulation.
CHECK GUARDS to make sure all are in proper position and securely tightened.
STARTING-STOPPING
Know beforehand how to stop the engine and rotation of the DETHATCHER or SLICER shaft in preparation for possible emergencies.
The engine of the DETHATCHER/SLICER is stopped by pulling the engine THROTTLE CONTROL to the rear to “STOP”. See Figure 2
ShaftrotationisstoppedbyreleasingtheCLUTCHCONTROL BAIL. See Figure 3.
Figure 3
OPERATE ENGINE AS FOLLOWS:
STEP 1:
Move HEIGHT ADJUSTMENT LEVER to “TRANSPORT” position. (This insures that the Shaft Assembly is clear of the ground/pavementshouldaccidentalengagementofCLUTCH CONTROL BAIL occur.) See Figure 4.
Figure 2 | Figure 4 |
4
