Yazoo/Kees ZCBI48181 manual Assembly

ASSEMBLY

Adjustments may be required to get uniform positioning of the control lever. Refer to the "Service and Adjustment" section of this manual.

NOTE: You may now roll or drive the mower off of the skid. Follow the appropriate instruction below to remove the mower from the skid.

CONTROL

LEVER

CONTROL

ARM

HEX

BOLTS

NEUTRAL

SLOT

TO DRIVE THE MOWER OFF OF THE SKID (See Operation section for location and function of controls)

WARNING

Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure the mower is in a well-ventilated area. Be sure the area in front of the mower is clear of other people and objects.

• Be sure all of the above assembly

steps have been completed.

• Check engine oil level and fill fuel

tank with gasoline.

• Place the IZT(Integraded Zeroturn

Transaxle) bypass linkages into the

drive position (See “TRANSPORT” in

the Operation section of this manual).

• Sit on the seat in the operating

position, set the park brake lever to

FIGURE 2

CZ-2

the on position.

• Rotate the control levers outward

into the neutral slot.

TO ROLL THE MOWER OFF OF THE SKID (See Operation section for location and function of controls

•Move to the rear of the mower, and place the IZT (Integraded Zeroturn Transaxle) bypass linkages into the bypass position to disengage the IZT’s (See “TO TRANSPORT” in the Operation section of this manual).

•Sitting on the mower, press the deck lift pedal in to the highest cutting position.

•Release park brake lever.

•Roll the mower forward or backward off of the skid.

• Press forward on the deck lift pedal

to raise the deck into the highest

cutting position.

• Place the throttle control into the

choke position.

• Start the engine. After the engine

has started, move the throttle control

to the idle position.

• Release the park brake.

• Move the control levers into the

operate position.

• Slowly move the control levers

forward and slowly drive the mower

off of the skid.

• Return the control levers back to the

neutral position.

• Apply the park brake.

• Turn the ignition key to the “OFF”

position.

13