York 48, 36, 60 Factory-Installedoptions, Field-Installedaccessories, Unit Cutaway, YTG-A-0506

255040-YTG-A-0506

		20 GAUGE ALUMINIZED	POWER VENTOR MOTOR
		STEEL TUBULAR HEAT	WITH POST PURGE CYCLE
		EXCHANGER
	DIRECT OR		HIGH EFFICIENCY
	BELT DRIVE
ECONOMIZER			COMPRESSOR
	BLOWER
HOOD

COPPER TUBE/

ALUMINUM FIN

CONDENSING

COIL

SLIDE-IN

ECONOMIZER

	FULL PERIMETER
	BASE RAILS WITH
SIDE RETURN	FORKLIFT SLOTS
AIR DUCT OPENING	AND LIFTING HOLES

BOTTOM		KNOCKOUT FOR SIDE
		GAS SUPPLY ENTRY
RETURN
AIR DUCT	3/4” PVC FEMALE
OPENING	CONDENSATE DRAIN	LOW VOLTAGE CONTROL
		BOARD
	KNOCKOUTS FOR
	SIDE POWER AND
	CONTROL ENTRY

FIGURE 1 - UNIT CUTAWAY

FACTORY-INSTALLED OPTIONS

•SINGLE INPUT ELECTRONIC ENTHALPY ECONO- MIZERS - Includes a slide-in /plug-in damper assembly with fully modulating spring-return motor actuator capa- ble of introducing up to 100% outdoor air with nominal 1% leakage type dampers.

The enthalpy system contains one sensor that monitors the outdoor air and determines when the air is cool enough and dry enough to provide free cooling.

The rainhood is painted to match the basic unit and must be field-assembled before installing.

•PHENOLIC COATED CONDENSER COILS - Special coating process that utilizes Technicoat 10-1TMpro- cesses. Coating is applied by total immersion of the com- plete coil for maximum protection.

•BELT DRIVE INDOOR FAN - Includes belt drive indoor fan and motor with unit access for belt adjustment and service.

FIELD-INSTALLED ACCESSORIES

•SINGLE INPUT ELECTRONIC ENTHALPY ECONO- MIZERS - Includes a slide-in /plug-in damper assembly with fully modulating spring-return motor actuator capa- ble of introducing up to 100% outdoor air with nominal 1% leakage type dampers.

The enthalpy system contains one sensor that monitors the outdoor air and determines when the air is cool enough and dry enough to provide free cooling.

The rainhood is painted to match the basic unit and must be field-assembled before installing.

•MOTORIZED OUTDOOR AIR INTAKE DAMPER - Includes a slide-in /plug-in damper assembly with a 2- position, spring return motor actuator which opens to some pre-set position whenever the supply air blower is operating and will drive fully closed when the blower unit shuts down.

The rain hood is painted to match the basic unit and must be field assembled before installing.

Unitary Products Group 5