Yorkville Sound LS800P Mono Blend, Input Jack, Protection, Note the Mono, Blend Input is

jacks are connected								6. Mono Blend
in parallel, you can use								Input Jack
them to daisy-chain			INPUT		LS800P		HF ROLLOFF	The Mono Blend Input
					LEVEL		SHAPE FREQUENCY
other LS800Ps or full	CLIP
								jack enables you to
range enclosures.
	LIMIT	LINE		SPKR				connect a secondary
					dB		LOUD DEEP 90 Hz 150
						12
Note: the Mono	PWR							line level signal to
								the system without
Blend Input is								externally summing the
						LINK
intended for Line	Yorkville							two signals (e.g. Left
Level signals only!								and Right). This is helpful
	NOTE: MONO BLEND INPUT				INPUT		OUTPUT
	IS LINE LEVEL ONLY!							when you are adding a
For normal operation,	MONO BLEND INPUT				INPUT		OUTPUT
								single LS800P to a stereo
connect the LS800P
								system. By using this
just like an ordinary
								input for your secondary
speaker along with the
								signal, it is blended
full range enclosures.
								internally with the Link
Set the Input Level
								input but isolated to
switch to Speaker if
								prevent interaction of
the signal is coming
								those signals.
directly from a power
						7. Protection
amplifier, ‘powered’ mixer, or other powered
source. If the LS800P is receiving the signal						The LS800P has circuitry to prevent clipping,
from a non-poweredmixer, a line level signal						over current and over excursion. At high
processor (as in an equalizer) or another line-						levels the limiter will limit the gain of the
level source, set the input switch to Line.						LS800P and hence if the user attempts to set
The LS800P may be plugged in before or						the subwoofer level control at a high level,
after the full range enclosure. The LS800P						the resulting setting will be incorrect. The
does not alter the signal to the daisy chained						level control should be set while operating
enclosures and will not draw any power from						at low levels (under 10 watts). If the level
the host amplifier/processor driving them.						control is set too high due to setting it at high
Also, note that an external crossover is not						operating levels the input circuit will clip and
necessary when using the LS800P.						the dynamics of the bass will be lost. The Red
						Clip indicator will signify when this occurs. This

As well as accommodating full range	can happen without audible distortion since
enclosures, the Link jacks allow many LS800Ps
	the filters will filter out the distortion.
to be connected in a string (parallel). There
is no practical limit to the number of LS800Ps
that may be connected together.

AT HIGH POWER LEVELS WHEN THE LIMITER IS OPERATING INCREASING THE SUBWOOFER LEVEL CONTROL WILL NOT INCREASE THE OUTPUT. DO NOT INCREASE SETTING WHILE OPERATING AT HIGH LEVELS.

Note: The LS800P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support our E160 cabinets. The support tube can be adjusted up to it’s full 5-foot 4-inch extension safely as long as the LS800P is not inclined mor than 10° (10-degrees).

WARNING: Larger or heavier cabinets shound not be used!

2