Z Microsystems 21 manual Installation Test, Final Adjustments

INSTALLATION

INSTALLATION TEST

The Glider should easily close completely.

Slide the Glider in and out several times. The Glider should slide in and out easily.

Because of variances in cabinet frames, there may need to be some adjustments of the Glider slide system for best fit and movement of the Glider in and out.

If the Glider binds when rolling in and out, perform the following procedures.

FINAL ADJUSTMENTS

Slide the Glider partially out.

Use a flathead screw- driver to slightly move the Z-Locks in toward or out from the Glider, depnding on the need for best fit. While holding the Z-Locks at the proper setting, tighten the screws on the Z- Lock mounts.

The Glider should slide in and out easily. If not, adjust the position of the two Z-Locks again.

10

Go to the rear of the cabinet to tighten the slider extender rail scews. If there is not enough room to work at the back of the cabinet, the Glider may need to be removed to tighten the rail screws.

The Glider should now slide in and out smoothly. If not, repeat these steps.

Doc# 27-0017UM Issued 08/03 Rev 1.0