Monitor Adjustments
NOTE: The H Wd parameters must be properly set in order for the Clock settings to have their desired effect. The Clock settings are the final fine tuning adjustments.
SAVING SETTINGS
NOTE: Cycling the power without the proper “wait time” will cause the last value change to be lost. The previous setting will be restored when power is returned.
V Pos
Moves the screen image up or
down. |
|
Clock |
|
The “Clock | “ controls |
move the sampling points left or right while maintaining a fixed distance between samplings. These adjustments ensure that the sampling occurs at the peak of the input video signal (i.e. neither too early nor too late), thus eliminating any panel fuzziness or discolora- tion. When properly set, all vertical lines on the panel should look very crisp.
HWD
Increasesor
Decreases
the horizontal screen size (width) by reducing or enlarging the sam- pling distance to synchronize the sampling frequency with the signal frequency. When properly set, no vertical banding will be noticeable.
Brt
Decreases or increases brightness of the backlight.
To save the screen settings for use in a future session, and through loss of power or video signal, allow 5 seconds to pass between the last adjustment and the time when power is restored to the system. The display will return with the values you had last set when the power is restored.
18
Doc#
