Zanussi DA 6141 D manual To fill, Rinse aid, Filling with rinse aid, Adjusting the dose

Only use salt specifically designed for use in dishwashers.

All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener.

Only fill with salt just before starting one of the washing programmes (except the Rinse and Hold programme). This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion.

To fill:

1.Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise.

2.Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time).

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about

110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting.

Rinse aid can be added in one of two ways:

● If you are using dishwasher detergent that already contains

rinse aid, the detergent including the rinse aid is placed in

the detergent compartment.

- In this case the rinse aid compartment must be empty.

If in the rinse aid dispenser there is still rinse aid you

must wait until it has finished before using detergent that

contains rinse aid.

● If you are using dishwasher detergent and rinse aid

separately, the rinse aid is to be put into the rinse aid

3.Using the funnel provided, pour in the salt until the container is full.

4.Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket.

5.Screw on the cap tightly turning it clockwise until it stops with a click.

SALE

ZOUTT

SAL

SALZ

SEL

SR14

dispenser.

- In this case the rinse aid dosage must be set in position

from 1 to 6 (see "Adjusting the dose").

Filling with rinse aid

(Rinse aid dispenser type A)

1.	Open the container by pressing the release button (A).
2.	Fill with rinse aid exactly up to the level indicator marked
	"max".

The salt container will require topping up periodically.

According to the model of dishwasher, you are reminded of this by:

A)The salt cap has a refill indicator window in the centre.

A green float is clearly visible when there is salt inside the container and almost disappears when the salt has finished reminding you to add salt.

BR07

BR14

B)A salt indicator light on the control panel will come on when the salt has finished.

The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected.

Do not worry if water over flows from the unit when filling with salt, this is quite normal.

Ensure that the lid is closed after every refill.

Adjusting the dose

According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage).

Increase the dose if there are drops of water or lime spots on the dishes after washing.

The dose is factory set in position 4.

Reduce it if there are sticky whitish streaks on the dishes.

BR09

4