Zanussi DA 6142 Fitting under a counter, Levelling, Technical specifications, Proceed as follows

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

570	-
	600
820
600
IN05

Proceed as follows:

Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

If the dishwasher is later used as a free-standing appliance, the original worktop must be re-mounted.

The plinth on free-standing appliances is not adjustable.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Technical specifications

Dimensions	Width	60 cm
	Height with worktop	85 cm
	Height without worktop	82 cm
	Max depth	63.5 cm
	Max depth with open door	118.5 cm
Electrical connection:	Information on the electrical connection is given on the rating plate on the
Voltage	inner edge of the dishwasher’s door.
Overall power
Fuse
Water supply pressure	Minimum	50 kPa (0.5 bar)
	Maximum	800 kPa (8 bar)
Water supply connection		cold water
Capacity		12 place settings

This appliance complies with the following E.E.C. Directives:

-73/23 or 19.2.73 (Low Voltage Directive) and subsequent modifications;

-89/336 or 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.

7