Operating sequence
1.Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
2.Press the
button
The
3.Check that there is rinse aid
and salt
The corresponding indicator lights will illuminate if refilling is necessary.
4.Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5.Ensure that the spray arms can rotate freely.
6.Measure out detergent
Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart.
Close the detergent dispenser lid.
7.Close the dishwasher door
8.Setting and starting the
programme
Press the push button corresponding to the required programme: the indicator light corresponding to the programme illuminates and the phase indicator lights for that programme start flashing.
The start of the programme will occur after about 6 seconds from the last pressure of a push button, in this time it is possible to change the programme simply pressing the push button of another programme.
Once the programme has started the phase indicator lights will turn off except for the phase under way.
It is possible to interrupt the programme by:
●opening the door
●pressing the
Close the door again o press the
was interrupted.
9.To cancel a programme in progress
A programme in progress can be cancelled at any time.
Press for about 3 seconds the push button of the running programme until all indicator lights are off.
Only the
It is now possible to select a new washing programme.
10.At the end of the washing programme
The dishwasher will automatically stop and the phase indicator light end of programme will come on.
The indicator light of the programme just ended will remain on.
16