Zanussi DE 6744 S manual Before use, Setting the water softener, Press Intensive SID, Normal

Before use

Before using your dishwasher for the first time:

1.Ensure that the electrical and water connections comply with the installation instructions

2.Remove all packaging from inside the appliance

3.Set the water softener

4.Pour 1 litre of water inside the salt container and then fill with salt

5.Fill the rinse aid dispenser.

Setting the water softener

The dishwasher is equipped with a water softener designed to remove minerals and salts from the water supply, which would have a detrimental or adverse effect on the operation of the appliance.

The higher the content of these salts, the harder your water is.

Water hardness is measured in equivalent scales, Clarke degrees, French degrees and PPM (parts per Million).

The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.

The dishwasher is factory set at level 3.

If this level is not suitable for your area the softener should be adjusted.

To select a different level be sure that the dishwasher is off and then proceed as follows:

1.Press INTENSIVE SID 80	and NORMAL
programme push buttons simultaneously.

2.While keeping the programme push buttons

INTENSIVE SID 80			and NORMAL	pressed
switch on the dishwasher by pressing the
ON-OFF		push button.
The	ON-OFF		indicator light comes on.
At the same time, also the indicator light of the
INTENSIVE SID 80			comes on and remains fixed
for about 5 seconds, after this it starts flashing
indicating the current level of the water softener.

				Water hardness
Level		Clarke			French			PPM	Use of
		degrees			degrees		(Parts per		salt
					(°TH)		Million)
1			< 6			< 8		< 80	NO
2	6		- 21		8	- 30	81	- 300	YES
3	22		- 35		31	- 50	301	- 500	YES
4	36		- 49		51	- 70	501	- 700	YES
5	50		- 63		71	- 90	701	- 900	YES

SO362

6