Zanussi DES 959 Adjusting the worktop, Fitting under a counter, Levelling, Proceed as follows

Models: DES 959

1 28
Download 28 pages 11.12 Kb
Page 27
Image 27
Adjusting the worktop

Adjusting the worktop

You can move the worktop forward or backward by

25 mm in order to align the machine with other kitchen units.

Simply unscrew the two rear retaining screws, move the top to the required position and then retighten the screws.

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Proceed as follows:

-Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

IN26

570

-

 

600

820

 

600

 

IN05

 

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

IN06

IN07

27

INS18UKen

Page 27
Image 27
Zanussi DES 959 Adjusting the worktop, Fitting under a counter, Levelling, kitchen worktop or sink, Proceed as follows