Operating sequence
1.Press the On/Off push button
The On/Off indicator light comes on, also the indicator lights of the last selected programme and relative options come on.
2.Check that
there is rinse aid and salt
The corresponding indicator lights will illuminate if refilling is necessary.
3.Open the door and check the
filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
4.Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it. Slide the baskets back into the machine.
5.Ensure that the spray arms can rotate freely.
6.Measure out detergent
Add the required amount of detergent into the dispenser.
Close the detergent dispenser lid.
Important!
If "half load" option is selected remember to reduce the quantity of detergent
7.Close the dishwasher door
8a. Setting and starting the programme without "delay start"
Press the push button corresponding to the desired programme. The indicator lights of the programme and all the phases the programme consists of will come on. In the digital display appears the duration (in minutes) of the programme.
●Select if necessary the washing on only one basket by pressing the half load push button.
Remember to load all dishes into the selected basket.
Press "programme start" push button, an audible signal advises you that the programme has started.
The display will show the running time
of the programme and the indicator lights of the phases will turn off except for the indicator light of the current phase.
The time in the digital display will start to decrease from minute to minute.
If the door is opened during the run of the programme the current phase will be interrupted and the indicator light of the interrupted phase will start to flash.
Once the door is closed the programme will start from the point where it was interrupted.
16 | SEQ32en |
