Zanussi DW 911 manual Operating Sequence, Check that the filters are clean, Load the dishes

Models: DW 911

1 20
Download 20 pages 38.31 Kb
Page 14
Image 14
Operating Sequence

Operating Sequence

1. Check that the filters are clean

(see cleaning instructions)

2.Check that there is salt and rinse aid

3.Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

Ensure that the spray arms can rotate freely.

4. Measure out detergent

Pour the required amount of detergent into the dispenser according to the indications in the «Washing programmes chart» and close the lid.

Close the dishwasher door.

5. Set the programme

Turn the «programme selector dial» clockwise until the letter of the programme you wish to select corresponds with the «programme marker».

SO121

7. Start the programme

Depress the ON/OFF pushbutton.

The indicator light will come on and the machine will start. If you wish to interrupt the wash at any time press the button again.

To restart the machine, depress the same button again and the programme will continue from the point where it was interrupted.

8. At the end of the washing programme

At the end of the washing programme the dishwasher will stop automatically.

The indicator light remains on until the ON/OFF but- ton is depressed.

When the programme has finished you are advised to unplug the appliance and turn off the water tap.

Open the door and wait a few minutes before removing the dishes; in this way you will avoid burning your fingers and drying will be improved.

Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.

Caution

In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.

If you have to open the door while the machine is work- ing, always switch off the appliance first by pressing the ON/OFF button.

Do not open the door during the hot phases: this may cause hot water escape.

6. Select the temperature

Select the temperature according to the instructions in the «Washing programmes chart» (see «Required pushbuttons»).

When the « 55°c» button is depressed, the main wash is at 55°C.

If the «55°c» temperature button is not depressed, the main wash will always be at 65°C.

PSO29GB

14

Page 14
Image 14
Zanussi DW 911 manual Operating Sequence, Check that the filters are clean, Check that there is salt and rinse aid