Zanussi IZZI Hints for test centres, Fitting under a counter, Levelling, kitchen worktop or sink

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.

Proceed as follows:

-Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

570	-
	600
820
600
IN05

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

Hints for test centres

Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispe				nser.
	Test standard	EN	50242
	Reference programme:	50° ECO
	Load:		12 standard place settings
	Rinse aid selector:	position 5
	Detergent dosage :	25 g in the dispenser
			5 g on the dispenser lid

Arrangement upper basket

Arrangement lower basket

Arrangement cutlery basket

Arrangement knife basket

15