Operating Sequence
Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Turn the programme selector dial to “0”; lights 
and 
go out.
Release the ON/OFF button (the
Drying
1.Connect the appliance.
2.Open the door.
After each use
• | Turn the programme selector dial to “0”. |
• | Switch the appliance off by releasing the ON/OFF |
P1149 |
P1108 |
| button . The |
• | Clean the filters (see page 10). |
• | Empty the water reservoir (see page 11). |
Important!
If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position 
(cooling) and wait until the end of this phase before removing the
3.Load the items one at a time, shaking them out loosely.
4.Close the door. Please check the laundry does not get caught between the door and filter.
5.Press the ON/OFF button 
: the
6.Select the drying programme or time.
7.If required, press the low temperature button 
and/or the buzzer OFF button 
.
8.Press the Start button 
for 2 seconds: light 
comes on and drying starts.
The drum turns alternately in both directions during drying.
All drying programmes end with a 10 minute cooling phase (light 
is on).
You may remove the
laundry after this phase.
9.If the laundry is not removed at the end of the cycle, the dryer performs an
The buzzer sounds every 10 seconds (if button 
has not been pressed).
Lights 
and 
flash alternately.
If you do not remove the laundry, the dryer will stop automatically at the end of the
Lights 
and 
flash and the
laundry. This will avoid a 
and depress START Button 
.
Modifying the programme
To change a programme which is running, first cancel it by turning the programme selector dial to “0”. Select the new programme and press the Start button 
.
8
