Problem |
| Possible cause |
The appliance does not operate. |
| The appliance is switched off. |
The lamp does not operate. |
|
|
|
| The mains plug is not connected to the |
|
| mains socket correctly. |
|
| The appliance has no power. There is |
|
| no voltage in the mains socket. |
|
|
|
The lamp does not work. |
| The lamp is in |
|
| The lamp is defective. |
The compressor operates contin- |
| The temperature is not set correctly. |
ually. |
|
|
|
| The door is not closed correctly. |
|
| The door has been opened too fre- |
|
| quently. |
|
| The product temperature is too high. |
|
|
|
|
| The room temperature is too high. |
Water flows on the rear plate of |
| During the automatic defrosting proc- |
the refrigerator. |
| ess, frost defrosts on the rear plate. |
Water flows into the refrigerator. |
| The water outlet is clogged. |
|
| Products prevent that water flows into |
|
| the water collector. |
Water flows on the ground. |
| The melting water outlet does not flow |
|
| in the evaporative tray above the com- |
|
| pressor. |
The temperature in the appliance |
| The temperature regulator is not set |
is too low. |
| correctly. |
The temperature in the appliance |
| The temperature regulator is not set |
is too high. |
| correctly. |
|
| The door is not closed correctly. |
|
| The product temperature is too high. |
|
|
|
|
| Many products are stored at the same |
|
| time. |
|
| There is no cold air circulation in the |
|
| appliance. |
|
|
|
Solution
Switch on the appliance.
Connect the mains plug to the mains socket correctly.
Connect a different electrical appliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than necessary.
Let the product temperature decrease to room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula- tion in the appliance.
8