Warning! This appliance must be earthed.
The manufacturer declines any liability should these safety measures not be observed.
12
3
4
5
Important! The wires in the mains lead are coloured in accordance with the following code:
| Green and Yellow: | Earth |
1 | ||
| Brown: | Live |
3 | ||
| Blue: | Neutral |
5 |
As the colours of the wires in the mains lead of this appli- ance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
1.Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol 
or coloured green and yellow.
2.Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black.
3.Connect the wire coloured brown to the terminal ei- ther marked with the “L“ or coloured red.
4.Check that no cut, or stray strands of wire is present and the cord clamp 4 is secure over the outer sheath.
5.Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
6.Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in the plug sup- plied, a 13 amp ASTA approved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure
that it is disposed of safely.
Door reversibility
The door of the appliance opens to the right. If you want to open the door to the left, do these steps before you install the appliance:
• | Loosen the upper pin | • Loosen the middle |
| and remove the spacer. | hinge. |
• | Remove the upper pin |
|
| and the upper door. |
|
•Remove the lower door.
•Loosen the lower pin.
On the opposite side:
•Install the lower pin.
•Install the lower door.
•Tighten the middle hinge.
•Install the upper door.
•Tighten the spacer and tighten the upper pin.
10
