Solutions to Common Problems 21
DISHWASHER WON’T FILL | ERROR CODES |
•Check to see if the water supply is turned on.
•Add 1/2 cup of water to the bottom of the unit and start again.off.
DISHWASHER HAS AN ODOR
•Soiled dishes left in dishwasher too long can create an odor. Use Rinse cycle.
•There will be a “new” smell when first installed. This is normal.
•Check to see if unit is draining properly (See Dishwasher Does Not Drain Properly, page 21).
REMOVING SPOTS AND FILM
Hard water can cause lime deposit buildup on the interior of the dishwasher. Dishes and glasses may also get spots and film for a number of reasons (See Glassware/Flatware Spotted or Cloudy, page 19).
To remove build-up, spots and film, clean
using the following instructions:
1Load clean dishes and glasses in normal manner. Do not load any metal utensils or silverware.
2Do not add detergent.
3Select the NORMAL WASH cycle. Press START/CANCEL pad and close door.
4Allow dishwasher to run until it begins the second fill. Open door and pour 2 cups of white vinegar into the bottom of dishwasher.
5Close and latch door and allow cycle to finish.
NOTE
In certain situations which are critical to machine function and safe operation. Error codes will be shown in the status window on the EIDW6305.
Er 01
Leak Detector - When water is detected under the tub.
Er 02
Thermistor - When thermistor/turbidity module fails
Er 03
Wash Pump - Wash pump not operating Er 04
Drying Damper - Drying damper not operating Er 05
Upper Fan - When in the dry cycle, the control board does not receive proper speed feedback from the upper fan
Er 06
Lower Fan - When in the dry cycle, the control board does not receive proper speed feedback from the lower fan
Er 07
Drain Valve - When in the drain mode, the control board does not receive proper position feedback from the drain valve
Er 08
Tactile or touch switch - Control board has verified a switch on the user interface is bad or shorted
Er 09
Communications - Communication failure be- tween main user board and power supply
Er 10
Mains Relay - Failure in the mains power relay Er 11
Drain Valve - Time out before finding a state for the drain valve
Er 12
Drain Valve - The drain valve is running when it should be off
Er 13
System wide - Lost control of the State Machine
If these conditions persist, a home water softener should be considered.