Control panel
1 |
| 2 |
| 3 |
| 4 |
| 5 |
1Pilot light
2Temperature regulator
3Fast Freeze light
4Fast Freeze switch
5Alarm light
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium setting.
The pilot light will light up.
Important! If the temperature inside the appliance is too high the Alarm light will blink. Active the Fast Freeze function.
Switching off
To turn off the appliance, turn the Temperature regulator to the "O" position.
The pilot light will switch off.
Temperature regulation
The temperature is automatically regulated. To operate the appliance, proceed as follows:
•turn the Temperature regulator toward lower settings to obtain the minimum coldness.
•turn the Temperature regulator toward higher settings to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on:
•room temperature
•how often the door is opened
•the quantity of food stored
•the location of the appliance.
Important! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
Fast Freeze function
You can activate the Fast Freeze function by pressing the Fast Freeze switch.
The Fast Freeze light will light up.
This function stops automatically after 52 hours.
It is possible to deactivate the function at any time by pressing Fast Freeze switch.
The Fast Freeze light will switch off.
Excessive temperature alarm
An increase in the temperature in a compartment (for ex- ample due to an power failure) is indicated by flashing of the Alarm light.
When normal conditions are restored the Alarm light will switch off automatically.
First use
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a
Important! Do not use detergents or abrasive powders, as these will damage the finish.
4
