Zanussi ZBM 799 Installation Instructions, Electrical Connections, This Appliance Must Be Earthed

Installation Instructions

It is mandatory that all operations for the installation of this cooker be carried out by qualified and compe- tent persons to the relevant British Standards.

The manufacturer declines all responsability if safety regulations are not strictly observed.

Before the appliance is connected, check that the main fuse and the domestic installa- tion can support the load; and that the power supply is properly earthed.

The manufacturer disclaims any responsabi- lity should these safety measures not be car- ried out.

This appliance meets the requirements laid down in EEC Directive No. 89/336 relating to the suppression of radio and TV interfe- rence.

Electrical Connections

The oven is designed to be connected to 220-240V (50Hz) electricity supply. The oven has an easily accessible oven block which is marked as follows:

Letter L -	Live terminal
Letter N -	Neutral terminal
-	Earth terminal

THIS APPLIANCE MUST BE EARTHED

The cable used to connect the oven to the electrical supply should have the characteri- stics indicated in the table.

It is necessary that you install a double pole switch between the appliance and the electri- city supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in com- pliance with the current rules.

The switch must not break the yellow and green earth cable at any point.

Important

After installation and connecting, the cable must be placed so that it cannot at any point reach a temperature of more than 50°C or above the ambient temperature.

Model	Rating	Cable Cross	Fuse
		Section mm2	Min.
		and type of cable
ZBM	2,685	1,5
799X		Ho5 RR-F	13A

Insertion into Modular Furniture

For built-in appliances it is necessary that furniture has suitable dimensions; dimensions of the oven, of the space and instruction for insertion and assembly follow (Fig. 8). Compliance with safety regulations protection against contacts with electrical parts must be assured by a correct insertion of the appliance. All safety relevant parts, even a possible covering panel (if an appliance is placed at the end or at the beginning of a row of furniture) must be fixed in a way that it is impossible to remo- ve them without using tools. In modular fur- niture plastic material layers and veneered would should be treated with glue resistant to a temperature of 85°C. Plastic materials or glues not resistant to this temperature can cause deformations or ungluing.

Please ensure that when the appliance is installed it is easily accessible for the engi- neer in the event of a breakdown.

41