WHAT TO DO IF THE APPLIANCE DOESN'T WORK
If the appliance doesn't work properly check the following points before asking for service:
The flow of gas seems abnormal
Make sure that:
—the flame speader holes are not obstructed;
—the pressure regulator is working;
—the bottle valve is completely open.
Gas smell in the room
Make sure that:
—the gas valve is not open;
—the gas supply tube is well positioned and in good condition; remember to replace it at least once a year.
Never look for an escape of gas with a match; use instead soapy water.
The oven doesn't heat
—Make sure that the oven knobs are in the correct worrking positions.
Cooking time is too long
—Check that the temperature is correct for the type of food to be cooked.
The cooker produces smoke
—We advise you to clean the oven after use. Splashes of fat can occur during the cooking of meat and, if the oven isn't cleaned properly, these produce smoke and bad smell. (see paragraph concerning cleaning).
The oven lamp doesn't work
—The lamp has burnt out. To replace it follow the instructions given in the relative paragraph.
If, after following all the above checks the appliance still doesn't work, call your nearest Service Centre givin them all the necessary information, such as model and serial number of the appliance.
MAINTENANCE - TECHNICAL ASSISTANCE
The gas cocks must be periodically lubricated to ensure good working and safety.
Maintenance should be performed as follows:
•Remove the knob and panel after having taken out fastening screws.
•Loosen the two screws located at the sides of the cock bar.
•Remove the cone and clean it carefully.
•Then, apply a thin layer of grease non soluble in water, suitable for gas cocks. Take care not to obstruct the gas flow holes by an excess of grease.
Reassemble the whole with utmost care performing the operations described above inversely.
ORIGINAL SPARE PARTS
This machine, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results.
Any repair work which needs to be carried out should be done with the utmost care and attention.
For this reason we reccomend that for any problem you contact the dealer who sold it to you, or our nearest authorized Service Centre, specifying the nature of the problem and the particular model which you own.
Original spare parts, certified by the manufacturer of the product and marked with the following sign,
can only be found at our approved Technical Assistance Centres and in authorised Spare Parts Shops.
72
