Zanussi ZCOF636X manual First Use, Fill The Water Tank, Adjusting The Texture Of Ground Coffee

FILL THE COFFEE BEAN HOLDER

FIRST USE

FILL THE WATER TANK

•Water hardness:

-before filling the water tank make sure that the Brita filter is in place (see paragraph "Water supply").

-if the appliance has not been used for a long time it is advisable to replace the water in the tank with fresh water and to empty the boiler by pressing the coffee button (ref.4) repeatedly.

•Open the unit clamping lock (ref.24) using the key supplied.

•Pull the coffee machine out of the unit on the telescopic runners.

•Fill the water tank (ref.27) located on the left- hand side of the appliance with approx. 2,5 litres of water.

•Push the machine back into the unit and fasten the unit clamping lock.

•Open the unit clamping lock (ref.24) using the key supplied.

•Pull the coffee machine out of the unit on the telescopic runners.

•Pour approx. 200g of coffee beans into the coffee bean holder (ref.26) on the right-hand side of the appliance.

•Push the machine back into the unit and fasten the unit clamping lock.

ADJUSTING THE TEXTURE OF

GROUND COFFEE

•The machine is supplied already calibrated to grind coffee beans to the ideal texture.

•The texture of ground coffee can however be adjusted using the grinding texture knob (ref.2). Turn the knob clockwise for a finer texture and stronger coffee. Turn anticlockwise for a coarser grind and weaker coffee.

PROGRAMMING THE QUANTITY

OF GROUND COFFEE

•The machine is supplied already calibrated to supply the ideal measure of ground coffee for a cup of espresso.

•However, the quantity of ground coffee supplied can be increased or decreased as follows:

place the filter holder (ref.20) with a one-cup filter (ref.21) below the coffee dispenser outlet (ref.19) and press the grinder button (ref.18) gently, do not release the button immediately. After approx. 10 seconds the grinder will start, when the quantity required is reached (recommended measure 7g corresponding to 6 seconds of grinding) simply release the button (ref.18) and the amount is automatically programmed.

PRELIMINARY START-UP

•Only move the steam spout using the rubber handle.

•Turn the coffee machine on by pressing the ON button (ref.3). The orange indicator light (ref.8) lights up to indicate that the machine is connected to the power supply.

•Turn the steam knob (ref.1) anti-clockwise.

•Press the hot water button (ref.5) and wait until all the air in the boiler is released through the steam spout (ref.16) and water starts coming through.

•The red indicator light (ref.9) illuminates at the same time to indicate that the water in the boiler is being heated. When the red indicator

4