Zanussi ZDC 67550W user manual Laundry Empty Tank light

Models: ZDC 67550W

1 31
Download 31 pages 47.24 Kb
Page 11
Image 11

125987350.qxp 2007-01-09 15:02 Page 11

use electrolux 11

laundry.

“Empty Tank”” light

This light comes on at the end of the programme to remind you that the water reservoir must be emptied out. If this light illuminates during a programme this means that the water reservoir is full. The buzzer sounds, the programme stops, the light of the Start/Pause button flashes. This light comes on also when the water reservoir is not inserted correctly.

“Filter” light

This light illuminates at the end of the programme to remind you that the filters must be cleaned.

“Condenser” light

It comes on every 80 cycles to remind you that the condenser must be cleaned.

Cancelling a programme

Turn the selector dial to “Off” to cancel a programme which is running. You can now select a new programme.

At the end of the programme

If the laundry is not removed at the end of the cycle, the dryer performs an anti- creasing phase (duration: 30 minutes maximum).

If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase. Lights End/Anticrease, Filter and Condenser remain lit and the buzzer sounds for 2 minutes.

Turn the programme selector dial to “Off” to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty.

GB

If you open and then close the door before turning the selector dial to “Off” all the lights corresponding to the phases making up the performed programme come on.

After each use

Clean the filters.

Empty the water reservoir.

Important!

If the drying programme has to be stopped before it reaches the end, we recommend that you turn the pro- gramme selector dial to position Cooling and wait until the end of this cooling phase before removing the laundry. This will avoid a build-up of heat inside the appliance.To do this first turn the dial to “Off” and then to Cooling and depress Start button.

Modifying the programme

To change a programme which is run- ning, first cancel it by turning the pro- gramme selector dial to “Off”. Select the new programme and press the Start button .

Page 11
Image 11
Zanussi ZDC 67550W user manual Laundry Empty Tank light