Zanussi ZDC 67550W Programme information, Adjusting Level, Conductivity, Off =, Cancelling

125987350.qxp 2007-01-09 15:02 Page 16

16electrolux programme information

Programme information

Objective Implementation

Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water by using the following procedure.

1.Turn the programme selector dial to switch on the appliance.

2.In selection mode,press simultaneously the buttons DRYNESS and START.

Press the buttons down until the pilot lights above each ones begin to flash and one of the pilot lights indicating the drying phase lights Empty Tank, Filter and Condenser remains it.

Adjusting			:
the level of
	Press the START/PAUSE button sequentially: the level of
conductivity
	conductivity is indicated by the phase pilot lights, which light in
	various combinations as follows:
	LED lit	Conductivity	Approximate value µS/cm
		Low	< 300
		Medium	300-600
		High	>600

Normally, the appliance is factory-set to the highest level; however, certain models may be configured differently.

	Simultaneously press the buttons DRYNESS and START. Press the
	buttons down until the pilot lights above each ones stop flashing
	and the buzzer sounds.
Off =	To reset a programme and to switch off the machine turn the
Cancelling/
	selector dial to Off. Now can a new programme be selected.
OFF