Cleaning fluff filter
The filter collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filter must be cleaned after every drying cycle.
The warning light FILTER , is on to remind you this op- eration.
Caution! Never operate the dryer without fluff filter or with damaged or blocked fluff filter.
1.Open loading door and remove laun-
dry.
2. Remove the filter which is built into the lower part of the loading aperture.
3.Open the filter pressing the but-
ton, among two
slots on fingers. Clean the filter us-
ing dump hand or cloth. After a period of time, a patina due to detergent
residue on laundry forms on the filters. When this occurs, clean the filter with warm water using a brush. Close the filter and do not forget to put it back.
Warning! Before You place the filter, please check it there is nothing inside the filter seat.
4.The filter can be positioned only to one side. If po- sition is wrong, the filter overhangs.
If the filter will not snap into place, the loading door cannot be closed.
Cleaning the door
Clean periodically the interior part of the door to remove any fluff. Accurate cleaning ensures correct drying.
Cleaning the drum
Caution! Do not use abrasives or steel wool to clean the drum.
Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The
degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than ex- pected when removed from the dryer.
Use a standard domestic cleaner (e.g.
Clean operating screen and housing
Caution! Do not use furniture cleaners or aggressive cleaning agents to clean the machine.
Use a damp cloth to wipe down the operating screen and housing.
What to do if ...
Problem
Dryer does not work.
Drying results unsatisfactory.
Possible cause
Mains plug is not plugged in or fuse is not working correctly.
Loading door is open.
Have you pressed the START PAUSE button?
Wrong programme selected.
Fluff filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Remedy
Plug in at mains socket. Check fuse in fuse box (domestic installation).
Close loading door.
Press the START PAUSE button again.
Select a different programme the next time you dry (see “Programme chart” chapter).
Clean fluff filter.
Observe recommended loading vol- umes.
Uncover ventilation slots.
9
