Zanussi ZDT 5052 manual Maintenance and cleaning, Internal cleaning, Cleaning the central filter

Models: ZDT 5052

1 16
Download 16 pages 14.58 Kb
Page 11
Image 11
Maintenance and cleaning

Maintenance and cleaning

Internal cleaning

Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.

We recommend the use of

Finish Dishwasher Cleaner

every

3 months or run a 65°C wash without dishes

using detergent.

 

Regular use of Finish Dishwasher Cleaner cleans inaccessible

 

parts, eliminates unpleasant food odours and

helps prevent

 

the build-up of limescale.

 

 

 

Cleaning the central filter

(After each wash)

Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water.

Filters (B) and (C) are both removed by lifting up the outer one

(B)(pulling the central filter upwards); the smaller filter (C) can be removed by pressing the two tongues (D).

 

C

 

D

 

B

MA02

MA08

Once cleaned, refit the filter by pressing them down until they click into place.

Check that the SID is not clogged with detergent residue. If necessary rinse it under running water after having removed it from the basket by twisting it anticlockwise and pulling it upwards.

Fasten it back onto the support by turning it clockwise.

MA12

Never use your dishwasher without the SID dispenser. Since SID also ensures correct distribution of the water to the upper spray arm, running the dishwasher without it will impair the washing results.

External cleaning

Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....).

Cleaning the large filter

(Every week)

Clean the large filter (A) on both sides under running water, using a brush.

To take it out, remove the spray arm by pressing the two

tongues (E), turn the ring (F) anticlockwise and then slide the whole part out. refit the filter following the above instructions in reverse order.

E

A

F

MA03

The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results.

Cleaning the filters is vital to ensure correct operation of the machine.

Prolonged periods of non-operation

If you are not using the machine for any period of time you are advised to:

1.Unplug the appliance and then turn off the water.

2.Fill the rinse aid dispenser.

3.Leave the door ajar to prevent the formation of any unpleasant smells.

4.Leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location where the temperature is

below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it.

Moving the machine

If you have to move the machine (moving house etc....):

1.Unplug it.

2.Turn the water tap off.

3.Remove the water inlet and discharge hoses.

4.Pull the machine out together with the hoses. Avoid over tilting the machine during transportation.

11

Page 11
Image 11
Zanussi ZDT 5052 manual Maintenance and cleaning, Internal cleaning, Cleaning the central filter, External cleaning