Zanussi ZDT 5895 Setting the special salt dosage, First rinse cycle, Set up the dosage as follows

Setting the special salt dosage

The dosage of special salt for the water softening must be set to the corresponding hardness of the water. If the dosage is too small, scale particles will remain on the crockery and cutlery. Information regarding the wa- ter hardness and the hardness areas in the area in which you live can be obtained from the local Water Authority.

For a water hardness under 5dH, no special salt is nee- ded. In this case, the salt display (9) is continually illu- minated.

Set up the dosage as follows:

Turn the setting button using a coin or a screwdriver (Size 4) until the arrow on the knob points to the desi- red number (1 to 5):

The arrow must point to a number and the posi- tion must be engaged positively.

-Salt consumption: Depending on the setting 1 kg salt is sufficient for

at setting No. of rinses

1approx. 45

2approx. 25

3approx. 20

4approx. 15

5approx. 10

Setting 1:

Up to 12.5 French degrees of hardness (fH) (equiva- lent to 7 German degrees of hardness (dH))

Setting 2:

For 12.5 to 25 French degrees of hardness (fH) (equi- valent to 7 to 14 German degrees of hardness (dH))

Setting 3:

For 25 to 37.5 French degrees of hardness (fH) (equi- valent to 14 to 21 German degrees of hardness (dH))

Setting 4:

For 37.5 to 50 French degrees of hardness (fH) (equi- valent to 21 to 28 German degrees of hardness (dH))

Setting 5:

For over 50 French degrees of hardness (fH) (equiva- lent to over 28 German degrees of hardness (dH))

The first rinse cycle

-Before the appliance is used for the first time, run an Intensive programme.

4

3 5

2

1

10