29
Electrical connection
This appliance must be earthed.
The manufacturer declines any responsibility
should this safety measure not be observed.
Before switching on make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.

Changing a fuse

Your appliance is supplied with a 13 amp plug fitted. In
the event of having to change the fuse in the plug sup-
plied, a 13amp ASTA approved (BS1363A) fuse must
be used,
Should the plug need to be replaced for any reason,
proceed as described below.
The wires on the mains lead are coloured in accor-
dance with the following code.
Green and Yellow -Earth
Blue -Neutral
Brown -Live
The wire coloured green and yellow must be connec-
ted to the terminal marked with the letter ”E” or by the
earth symbol or coloured green and yellow.
The wire coloured blue must be connected to the termi-
nal ”N” or coloured black.
The wire coloured brown must be connected to the ter-
minal marked ”L” or coloured red.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure
over the outer sheath.
A cut off plug inserted into a 13amp socket is
a serious safety (shock) hazard.
Ensure that the cut of plug is disposed of sa-
fely.

Permanent connection

In the case of permanent connection it is necessary
that you install a double pole switch between the ap-
pliance and the electricity supply (mains), with a mini-
mum gap of 3mm between the switch contacts and a
type suitable for the required load in compliance with
the current electrical regulations.
The switch must not break the yellow and green earth
cable at any point.
Circuit: heating voltage 230V