Electrical Connection, Remove the top hinge cover, Brown

2 1

1.Remove the plug from the power socket.

2.Remove the top hinge cover.

3.Unscrew the 2 retaining screws, and remove the hinge from the appliance.

4.Take the door off.

5.Remove the screw fixing the lower door hinge and the other screw fixing the lower door hinge and the foot. Then remove the door hinge and the foot as shown in the Figure.

6.Loosen the screw fixing the foot opposite the lower door hinge in order to re- move the foot.

7.Fix the door hinge and the corresponding foot on the opposite side and then the other loosened foot at the former place of the door hinge as shown in the Fig- ure.

8.Please make sure to place the lower foot below the door hinge. The lower foot is recognizable by its 4 ribs on the outer surface.

9.Fix the door onto the lower hinge pin.

10.To fit top door hinge, remove the plastic blanking plugs carefully, and refit them in the holes left by the hinge retaining screws.

11.Refit the top hinge us- ing the 2 retaining screws, taking care that the edge of the door is parallel with side of the cabinet.

12.Replace the hinge cov-

er.

13.Relocate the handle and the plastic plugs to the op- posite side.

14.Level the appliance, wait for at least four hours and then connect it to the power socket.

Do a final check to make sure that:

•All screws are tightened.

•The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Winter), the gas- ket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket.

In case you do not want to carry out the above mentioned operations, contact the nearest After Sales Service Force. The After Sales Service specialist will carry out the rever- sibility of the doors at your cost.