INSTALLING THE COOKER HOOD
Fitting the Wall Brackets
•Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed.
•Draw a horizontal line at 650 mm above the hob for installation without the back panel, or at height H (H=height of the visible part of the panel) for instal- lation with the back panel.
•Place bracket 7.2.1 on the wall as shown about
•Mark the wall at the centres of the holes in the bracket.
•Place bracket 7.2.1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line.
•Mark the wall at the centres of the holes in the bracket.
•Place bracket 7.1 as shown 95 mm from the verti- cal reference line and 210 mm above the horizontal reference line.
•Mark the centres of the holes in the bracket.
•Repeat this operation on the other side.
REAR PANEL (OPTIONAL)
The Rear Panel must be fitted before fixing the hood body and, if it is to be fi xed at both top and bottom, must be
fitted at the correct height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a qualifi ed person who knows the fi nal dimensions of the units.
For fi xing at the top only, proceed as follows:
•Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line.
•Mark the centres of the two holes in the upper plate.
•Drill ø 8 mm holes at all the centre points marked.
•Insert the wall plugs (not supplied) in the holes.
•Fix the brackets using the screws (not supplied).
•Fix the back panel (where present) using the screws (not supplied).
Note: If the hood is to be installed onto a hollow con- struction or plaster or partition board wall then special fixing screws will be required (not supplied).
Fitting the Canopy Hood
•Screw the two screws item 12d supplied onto the brackets 7.1.
•Hook the hood body onto the bracket 7.1, centring it around the vertical line.
•Use the adjusting screws item 12d underneath the hood to level the hood body
| 1÷2 |
7.2.1 | X |
|
7.1 | 95 | 95 | 210 |
|
|
| |
650 min. |
|
| H |
12.d
7.1
13
