INSTALLATION INSTRUCTIONS
Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown.
All installations must comply with the local authorities requirements for the discharge of exhaust air.
Incorrect installation may affect the safety of this cooker hood.
Installation Requirements
Before installation check that the wall to which the cooker hood is to be fitted for electric cables, water pipes and gas.
This cooker hood is designed to be fixed to any vertical surface over a cooking area, and can be used in the extraction mode (ducting to the outside) or recycling mode (filtered).
The installation work must be undertaken by a qualified and competent person.
The manufacturer disclaims any responsibility for damage due to incorrect installation of the cooker hood or if the hood is not installed in compliance with relevant regulations controlling this type of installation.
Unpacking
Before unpacking the cooker hood position the carton with the arrows pointing upwards as illustrated on the carton.
The cooker hood is made up of the following components:
Ref Qty Product Components
11 Hood body, complete with controls, lighting, fan and filters.
21 Telescopic Chimney comprising:
2.1 | 1 | Upper section |
2.2 | 1 | Lower section |
15
14.1
7.2.1
10 | 14 |
9
2.1 | 12c |
|
2
8b
8a | 1 | Right recirculated air oulet grille |
8b | 1 | Left recirculated air outlet grille |
91
101
141 Recirculated air extension tube
14.1 2 Recirculated air outlet extensions
151 Air outlet connector
Ref Qty Installation Components
7.22 Upper chimney wall fixing brackets
12c 6 Chimney fixing screws
Ref Qty Documentation 1 Instruction booklet 1 Warranty
2.2
1
8a
Page 11
