Zanussi ZHQ 575 manual Fitting Into the Space Between Cabinets, Lifting procedure

INSTALLATION INSTRUCTIONS

FITTING INTO THE SPACE BETWEEN CABINETS

IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.

￿ Ensure the appliance is in front of the cabinet.

See Fig. 13.

￿ Take out all oven furniture before installation to

reduce the weight you need to lift.

￿ To place the appliance into the space between

cabinetry follow the procedure below:

￿ N.B. Two people will be required to carry out

the lifting procedure.

￿ Warning: Do not attempt to lift this appliance by

the handle(s).

Each person should squat either side of the

appliance.

Tilt the appliance so that your hands can support

the underside of the appliance.

Raise the appliance to the correct height.

Fig.13

Fig.14

Rest the rear underside of the appliance on the

mounting brackets while your hands support the

front.

The appliance can be pushed fully into the

space. Take care to avoid fouling the mains

lead.

Ensure the appliance is central and level.

￿ When the appliance is fully housed, screw the

stability screws (supplied with the appliance) into

WORK TOP

HEAT SHEILD

LEVEL WITH

FRONT EDGE

OF WORK

TOP

TOP OVEN

DOOR

the underside of the worksurface in the positions

indicated (see Fig. 14), taking care not to distort

the trim. It is advisable to turn each screw

alternatively to avoid damaging the trim.

￿ Place the heat deflector flush with the edge of the

worksurface, (see Fig.15) with the cork spacers

upover (see Fig.16) and screw into position using

the screws supplied with the appliance.

￿ Replace the plinth board.

￿ Switch on the appliance and refer the user to the

operating instructions.

Fig.15

Fig.16

58