Wall Cabinet Fitting
Before fitting the cooker hood beneath any type of wall cabinet ensure it is firmly fixed to the wall in accordance with the manufacturers instructions.
1.Use the paper template provided to mark the hole positions on the underside of the cabinet. Ensure the front edges of the template are aligned with the front edge of the cabinet carcase.
2.Check the distances are correct with a tape measure as stated on the template. The four holes are 5mm (1/4”) diameter.
3.If the ducting spigot is being used, cut a circular hole, using a pad saw or similar cutter.
Fitting the Cooker Hood to the Wall
1.Lift the hood squarely to the wall slightly higher than the screws (not supplied).
2.Lower the cooker hood until the cooker hood locates onto the two screws.
3.Ensure that the cooker hood is correctly located before letting go.
To Level the Cooker Hood
1.Remove the lower grille by pressing inwardly on the two slide catches located towards either side of the grille towards the front. The grille will open from the front.
2.Slide the right edge of the grille forward until it clears the guide and then unhook the left hinge pin.
3.Support the grille when removing it from the guides carefully.
4.The two levelling screws will be visible towards either end of the back panel.
14
