Zanussi ZJ 1217 manual Something Not Working

Something Not Working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below.

IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

During machine operation it is possible that the light END, the light of the START/PAUSE button and one of the following lights start to flash:

-RINSES: problem with the water supply

-WASH: problem with water draining

-PREWASH: door open

Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after all checks, the problem persists, contact your local Service Force Centre.

Symptom	Possible causes
The machine does not start	●	The door has not been closed.
	●	The plug is not properly inserted in the power socket.
	●	There is no current at the socket
	●	The main fuse or the fuse in the plug has blown.
	●	The selector dial is not correctly positioned.
	●	The START/PAUSE button has not been depressed.
The machine does not fill	●	Ensure the water tap is open.
	●	The filter in the inlet hose is blocked.
	●	The inlet hose may be squashed or kinked.
	●	The door has not been closed.
The machine fills then empties	●	The end of the drain hose is too low.
immediately	●	The end of the drain hose is submerged in water.
	●	There is no vent in the end of the drain hose.
The machine does not empty and/or	●	The drain hose may be squashed or kinked.
does not spin	●	The RINSE HOLD option has been selected.
	●	The drain filter may be blocked.
	●	The drain hose extension is not correct. Follow the instructions for
		connecting to the waste.
	●	The drainage system pipes are blocked.
	●	The wash load is unbalanced: redistribute the clothes inside the drum to
		allow the machine to spin.
There is water on the floor	●	Too much detergent or unsuitable detergent has been used (creates too
		much foam).
	●	Check whether there are any leaks from one of the inlet hose fittings. It
		is not always easy to see this as the water runs down the hose; check to
		see if it is damp.
	●	The drain hose may be damaged or not securely positioned.
	●	The detergent dispenser drawer or recess is clogged.
	●	The drainage system pipes are blocked.
Unsatisfactory washing results	●	Too little detergent or unsuitable detergent has been used. An
		insufficient amount of detergent leaves the laundry looking grey and
		causes lime scale to form.
	●	Stubborn stains have not been treated prior to washing
	●	The correct wash programme has not been selected.
	●	Too much laundry has been placed in the drum.

19