Zanussi ZJ 1217 manual Building-in, Preparation and assembly of the door

Building-in

This appliance has been designed to be built into the kitchen furniture.

The recess should have the dimensions shown in picture A.

		600
			600
			.
	515	596	min
			570
	176,5		min
818	416	120	820
		541	195
		8
		160
	165	90
		490	A
P0965

Preparation and assembly of the door

The machine is originally pre-arranged for the assembly of a door opening from right to left.

In this case it is sufficient to screw in the hinges (1) and the counter-magnet (6) provided with the appliance, at the right level (Fig. B).

6			4
1	2	7	5
1
		3
23			B
P0982

a) Door

The dimensions of the door should be: - width 595-598 mm

- thickness 16-22 mm

The height (C-Fig. C) depends on the height of the adjacent furniture's base.

35 Ø 12.5-14 depth
16		B
-
	22
		416	C
		22+1,5
		-598
		595
P0422S			C

b) Hinges

To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth 12.5-14 mm depending on the depth of door furniture) on the inner side of the door. The distance between the holes hobs fixing centres must be

416 mm.

The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions.

The required dimensions are given in the picture C. The hinges will be fixed to the door by means of screws for wood (2-Fig. B) supplied with the appliance.

c) Mounting the door

Fix the hinges (1) to the machine by means of the M5x8 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thickness of the door. To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door.

Its position must correspond to the magnet (4) on the appliance (see picture D).

	6
	4
P0984	D

If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate

(5)(Fig. B and E). Mount the countermagnet (6) and the hinges (1) as previously described.

			E
4			6
	5	7	1
			3
P0983			2

29